A is for Azusa

After seeing these letter on the side of the foothills all over Southern California, I decided to try to fly close to them via FPV. Here is me second attempt (the first one was B is for Burbank, click here to watch that video). Please excuse the excessive jello and vibes; the CC3D controller isn’t perfectly tuned and I’m using very cheap motors that are hard to balance. Other than that, enjoy!

Equipment used:

3D printed Mini H frame, the Mini Crow (click here for more info)
APC 6 x 4 props
Aoxing 2100 kv motors
600mw 5.8 Immersion RC Video TX
PZ0420 Clone board cam for FPV video
Mobius wide lens for video recording

Comments

comments

Julian Melo

Julian Melo has been around the R/C hobby since 2001. His first plane was PT-40 trainer from Great Planes he built as a kit, powered by an O.S. 40 engine. Nowadays you can find him flying fast EDFs or FPV multirotors. Professionally, he's an L.A-based web developer, Wordpress ninja & SEO Analyst. He is quite fond of good coffee, gadgets and loud garage rock. Check out his site/portfolio at JJMelo.com or read his technology blog. He also recently started a new site/podcast titled UAV not Drone. Check it out!